Comparison tool-life record
400CASE 01 / Automotive
External taper turning on a third-gear component
Application comparison using IKEN IKN6000C2 for turning an external taper on a third-gear component.
Workpiece and conditions
- Workpiece
- Third-gear component
- Material
- 20CrMnTi
- Hardness
- HRC58–62
- Machine type
- Combined turning and grinding machine
- Cooling
- Dry machining
- Operation
- Turning an external taper
01 / TOOLING
Tooling
- IKEN tool
- 2HP-CNGA120408-STH IKN6000C2
- Previous tool
- CNGA120408 (Imported)
Application objective
Maintain comparable tool life, validate an alternative tooling option and optimize tooling cost per part.
02 / CUTTING CONDITIONS
Cutting conditions
- Cutting speed Vc
- 160 m/min
- Feed per revolution f
- 0.15 mm/rev
- Depth of cut ap
- 0.15 mm
03 / APPLICATION RECORD
Recorded results
IKEN tool-life record
400The IKEN and comparison tools recorded the same tool life in this application.
Record notes
This case describes an application under the listed workpiece, tool and machining conditions. It does not guarantee tool life, cost or quality in other applications.
The source tool-life chart does not state a unit. The recorded values are shown without converting them into parts, time or output per edge.
Cost optimization is an application objective. The records do not include complete insert-price, machine-time and cost-per-part calculations, so no specific cost reduction is claimed.
Results apply to the workpiece and conditions recorded here. Tool life, surface quality and cycle time require validation for the actual material, machine, setup and parameters.